Triple Water Spray High Speed Dental Handpiece Stainless Bearing
Consists of handpiece head, handle, cartridge.
1. Air pressure 0.25~0.30mpa,must be filtrated.
2. Use high speed dental bur with shaft diameter
Φ1.59~1.60mm×21-23mm and roghtness less than 0.8um.
3. The amount of handpieces spray or water spray should be able to
4. Hard glass fiber,can be repeatedly sterilized in high
temperautre and pressure.
Only used for drilling, molar of stomatology clamping high-speed
HPA009 Handpiecewe Provide Two Kind Of Head For Choice
1. Clamping force of handpiece is:20-45N
2. Noise not exceed 70dB
3. At 25-30 atmosphele pressure,350,000-400,000R.P.M(Standard
Triple Water Spray Handpiece
1. Push Button High Speed Handpiece M4/B2
2. Working Air Pressure:0.20-0.25MPa(0.22MPa prefrred)
3. Rotation Speed:350,000-400,000R.P.M(Standard Head);
4. Bur Applicable:Φ1.595-1.600mm"
5. Spray:Triple water spray
1. Simple, effective, disassemble it without tools and can be
cleaned thoroughly to avoiding cross infection;
2. Stale, quite, and large torque cartridge;
3. Perfect stable and reliable performance;
4. 135C Auto rotation;
5. High -grade material with a stylish design
6. Self-illumination without connecting circuit
9. Application: odontoprisis, drill teeth, teeth clean etc.
1. Considering safety first, please be careful to use it with full
2. Be limited to dentists who held the dental treatment
3. Strictly forbid decomposition and reconstruction by
4. Please run point testing on outside of patients oral beforehand.
If feel anomalies, please stop using immediately and contact with
our after-sales center.
5. When appears abnormal during using, please stop it immediately
and contact with our after-sales center.
6. It will cause a high noise using a center-vibration or bended
bur and a handpiece of which bearing has been worn, A long time in
this state will be harm to people’s hearing. Forbid using a
vibration or bended bur, if appear high noise, please replace the
shaft core early
7. Do not use a bending , cracking, deformation and unqualified
bur. If using it, may cause a snap, or a flying off to injury
accident during operation process.
8. Please ensure the bur chuck be clean. If with contaminant inside
of it, may causes bur clamping weaken or shaft core vibration.
9. Please run the bur under the provision rotation-speed by bur
10. Do not crash, especially to avoid falling.
11. Please install a bur or a standard stick before using.
12. Aslo remember to install a bur or a standard stick when not in
13. Please unload the bur and handpiece when the running stopped in